Shandong China Coal
Rubber Paver Equipment Co., Ltd.

homeHome>information

What Are The Construction Precautions For Road Paver Machine?

Date:  Tag: Road Paver Machine Paver Machine Paver

In the past two years, we have been able to see that many rubber fields in the stadium are being re-constructed, and the requirements for the runway are getting higher and higher. The Road Paver Machine is an important equipment in the construction. What are the precautions when using it? What?

1. The Road Paver Machine should always check the operation of the vibrating stick. It was found that pitting or cracking occurred many times in the cross section on the road surface, indicating that there was a problem with the vibrating bar at the place. It was necessary to stop the inspection or replace the vibrating bar at the place. After paving, it was found that there was left on the road surface. The shiny rubber strip pulled by the shiny Road Paver Machine indicates that the vibrating bar is too deep and must be adjusted to the correct position until the bottom edge of the vibrating bar is above the height of the trailing edge of the extruded floor.

2. When paving the runway with a width greater than or equal to 2.5, if the rubber materials with inconsistent consistency of the two vehicles are unloaded left and right, the paving speed of the Road Paver Machine should be set on the side of the dry side, and the side should be thinner. The vibrating bar frequency is rapidly reduced.

3. When the rubber material is not supplied, or the mechanical failure occurs in the mixing building, the downtime shall not exceed 2/3 of the initial setting time of the rubber material at that time. Above this time, the Road Paver Machine shall be opened. Paving the work surface and making construction joints. When there is a mechanical failure in the Road Paver Machine, the building should be stopped after the emergency notification. The rubber material in the Road Paver Machine has not been initially set during the downtime, and the fault can be eliminated, and the paving can be continued. Otherwise, the road should be stopped as soon as possible. Paver Machine drags out the paving work surface. After troubleshooting, restart the paving.

The above is the introduction to the construction of Road Paver Machine, I hope you have some understanding. If you want to know more about Paver Machine, Road Paver Machine, Rubber Paving Machine, Running Track Paver Machine, PTJ-120 Sprayer Machine, Sprayer Machine, please stay tuned.

What Are The Construction Precautions For Road Paver Machine?